La Habra Copper Repipe and Slab Leak Repairs

A repipe is a process where the existing piping in a home or a building are replaced with brand new ones. All water pipe fittings, supply lines and water valves are changed. this usually ends up in greater water pressure and better quality water.

Should I Repipe our house in La Habra?

There are many reasons why you needs to replace the water pipes in your house.

For houses with galvanized water lines:

Galvanized water pipes are located in houses built during the 1970’s. A galvanized pipe is an iron water pipe which is zinc coated to be protected from corrosion. The sad thing is the zinc coating steadily deteriorates over the years exposing the iron material, and then oxidation buildup.

Typical Slab Leak Characteristics:

Reduced Water Pressure – The reason why could possibly be the restriction of the water flow caused by rust and corrosion buildup in the galvanized water pipe.

Rust Colored Water – Rust generally finds it’s way into the water fixtures. This indicates a high level stage of deterioration in your water pipes.

Leaking Pipes – Leaks are most frequently brought on by corrosion of the galvanized pipes. Unseen leaking may develop in the walls, within the attic as well as under the home, building up the likelihood of severe damage to the property.

For residences with polybutylene plumbing:

This type of plastic water pipe was widely used from the mid 70’s to the early 90’s. At the time it had been perceived as the next technological advance for water pipes and water fixtures. Polybutylene water pipe systems ended up being installed in millions of places of residence prior to being deemed highly defective. Nearly 65% of most family homes constructed in this time frame is still equipped with this variety of pipe in the home.

Polybutylene pipes have an enormously limited lifespan, because chemical products in typical city-provided water makes it firm up and change into brittle. The fittings frequently burst open first, followed by the water line itself.

Polybutylene water pipes consist of flexible plastic pipe, gray when for indoor use and blue or black outside. Certain fittings were created with plastic and metal. Insert fittings are used to join pieces of polybutylene pipe.

For houses with copper plumbing based in the slab.

Slab leaks are generated by copper or other piping becoming corroded from certain soil and water conditions under the floor of the house.

Symptoms of a Slab Leak:

  • Water leaking in your foundation.
  • Water is running even when no faucets are on.
  • Water meter indicates your water is running even when your water is turned off.
  • Abnormally significant water charges.
  • Neighbors have experienced a leaking slab.
  • You have experienced a previous slab leak.

Attributes of a Repipe

  • Higher water pressure
  • No rust color or bad tasting water
  • Sparkling clean, crystal-clear water
  • The ability to turn on more than one faucet at the same time
  • High quality water pipes without any more leaky pipes.
  • No scalding in the shower if someone else turns on your faucet or flushes.
  • Greater satisfaction because your piping system is dependable.
  • Very good feature for your property.

When you employ a plumbing technician or other company to perform the job, it’s quite possibly going to cost more in the long run when you consider that you will have to employ a drywall repair service provider to patch over the various entry points. When you seek the services of a repipe business with a master patcher on staff such as Repipe Specialists, you will never be required to invest additional money or time getting your house back to normal. From beginning to end, the PEX and Copper repipe process normally takes only two or three days.